Team:NTU-Singapore/Modelling/Sensitivity Analysis

From 2008.igem.org

(Difference between revisions)
(E7 production system Sensitivity Analysis)
(E7 production system Sensitivity Analysis)
Line 10: Line 10:
[[Image:Sensitivty_for_lactose.jpg|thumb|center|800px|Sensitivity Analysis for E7 Production]]<br>
[[Image:Sensitivty_for_lactose.jpg|thumb|center|800px|Sensitivity Analysis for E7 Production]]<br>
-
[[Image:Lactose_adjust.jpg|800px|thumb|Center|New E7 production ]]<br>
+
[[Image:Lactose_adjust.jpg|800px|thumb|center|New E7 production ]]<br>
We can compare the new adjusted E7 production system with the [https://2008.igem.org/Team:NTU-Singapore/Modelling/Deterministic_Modeling#E7_production_system previous modeling exercise]. The E7 and immunity protein production has been cut down.
We can compare the new adjusted E7 production system with the [https://2008.igem.org/Team:NTU-Singapore/Modelling/Deterministic_Modeling#E7_production_system previous modeling exercise]. The E7 and immunity protein production has been cut down.

Revision as of 00:57, 25 October 2008

Contents

Sensitivity Analysis

A sensitivty analysis for the two systems were performed using [http://www.sbtoolbox2.org/main.php SBtoolbox 2]. The reason for performing this analysis is to find out which are the important parameters and would have a major effects on the experimental results. A part of the reason is because some of the parameters were fitted and not obtained strictly from literature. This analysis would allow us to plan for experiments while taking into account the effect these parameters may have.

E7 production system Sensitivity Analysis

Sensitivity Analysis for E7 Production

New E7 production

We can compare the new adjusted E7 production system with the previous modeling exercise. The E7 and immunity protein production has been cut down.

Lysis production Sensitivity Analysis

The Sensitivity analysis revealed that the degradation rate of Proteins was a major factor and the previous assumption was not that accurate. The value for protein degradation was adjusted by assuming that the half time for protein degradation is 10 minutes. The new Lysis output according to the model is as follows.


Lysis

As we can see, the output of protein has been drastically reduced from the previous modeling exercise for the Lysis Protein Production system.

Updates