Team:NTU-Singapore/Modelling/ODE

From 2008.igem.org

Revision as of 01:42, 26 June 2008 by Lalala8585 (Talk | contribs)

Contents

ODEs used in modeling

The following equations shows the break down of the different equations that will be used in this modeling exercise. By understanding this section, it would make the understanding of the system of ODEs used


Constant synthesis & Linear Synthesis

Linear Synthesis

  • Simple ode to describe constant synthesis
  • Gives an explicit analytical solution
  • Unique solution once a IC is posed

Linear Degradation

Linear Degradation

  • Rate of degradation is proportional to how much of the molecule is present
  • Gives an explicit analytical solution
  • Constant half life

Simple Forward Reaction

Complex Formation

[C] : Complex
kc : Rate constant of complex formation

This equation ignores the fact that dissociation of the complex occurs. We can do so if the dissociation is much slower than the formation.

  • Single solvable equation for the unknown C
  • Simple, unique solution available with I.C

Phosphorylation and Dephosphorylation

Assumptions:

  • Linear kintic rate laws apply only if XT is much less than the Michaelis constants of both kinase and phosphotase

Phosphorylation and Dephosphorylation

XT : total cost of X protein in phosphorylated and unphosphorylated form
S : protein kinase concentration
k2 : accounts for protein phosphotase

  • Modeled after simple linear kinetics
  • Gives a hyperbolic signal response curve when X plotted vs S

Regulated Transcription

Regulated1

[P]: Protein Formed
µ: Repression, µ=0;
Activation, µ=1
K: Hill Constant Value of input that gives 50% response
n: Hill coefficient Slope of signal-response curve at this input signal
d: degradation of protein
k1: basal gene expression
k: signal-dependent gene expression
a: correlation between k1 and k, 0<a<1

Regulated2
This ODE attempts to capture characteristics of the mRNA dynamics
For our modeling, all our detection systems activates some form of transcription. Therefore µ=1 in all cases for our modeling exercise. Regulated3


ODE system used in model

Lactose controlled production of E7 + Imm

Variables

  • LacI = A
  • Lactose =B
  • E7 = C
  1. LacI production
    • Transcription of LacI gene mRNA

Lac1
[MA] : LacI mRNA concentration
k1A : kinetic constant of transcription
U : system input
d1A : degradation constant for mRNA

    • Translation of LacI Protein

Lac2
[PA] : Protein concentration
k2A : kinetic constant of translation
d2A : degradation constant for Protein

  1. Complex formation between LacI and Lactose

Complex
[ComAB] : Complex of LacI and Lactose
K3AB : Rate constant of complex formation
[PA]o : Protein concentration of LacI at the time of Lactose addition
[B]o : Initial concentration of Lactose

  1. E7 production
    • Transcription of E7 gene mRNA

E71
[MC]: E7 mRNA Concentration
k1C: kinetic constant of transcription
a : constitutive portion , 0<a<1
KC: Hill constant
nC: Hill coefficient
d1C: degradation constant for mRNA

    • Translation of E7 Protein

E72
[PC] : Protein concentration
k2C : kinetic constant of translation
d2C : degradation constant for Protein

Iron and Ai2 controlled production of Lysis

Variables

Variables

  1. Ai-2 : A
  2. ai-2-phos : B
  3. LsrR : C
  4. SupD derivatives : D
  5. T7ptag : E
  6. Lysis : F