Team:Chiba/Project

From 2008.igem.org

(Difference between revisions)
(→Delay Switching by Tuning Components)
(→For detail, click each of the index titles)
Line 103: Line 103:
|-
|-
| valign="center" align="center" width="50%"|
| valign="center" align="center" width="50%"|
-
[[Image:Chiba Igem 4.png|flame|'''Fig.7''' ]]
+
[[Image:Chiba Igem 4.png|130px|'''Fig.7''' ]]
| valign="center" align="center" width="50%"|
| valign="center" align="center" width="50%"|
-
[[Image:Chiba Igem 5.png|flame|'''Fig.8''' ]]
+
[[Image:Chiba Igem 5.png|130px|'''Fig.8''' ]]
|-
|-
| align="center"| '''[[Team:Chiba/Project/Experiments:Sender_Crosstalk|Exp #4 Spoken to by Foreign Senders]]'''
| align="center"| '''[[Team:Chiba/Project/Experiments:Sender_Crosstalk|Exp #4 Spoken to by Foreign Senders]]'''

Revision as of 07:32, 30 October 2008

Chiba-U.gif
Home The Team The Project Parts Submitted to the Registry Reference Notebook Acknowledgements

Abstract

　E. coli time manager

We are constructing delay switches to control/preset the timing of target gene expression. Our project uses two classes of bacteria: senders and receivers. Senders produce signaling molecules, and receivers are activated only after a particular concentration of this molecule is reached. The combinatorial use of senders/receivers allows us to make a‘switching consortium’which activates different genes at the preset times.

As signaling molecules, we utilize molecules associated with Quorum sensing, a phenomenon that allows bacteria to communicate with each other. Although different quorum sensing species have slightly different signaling molecules, these molecules are not completely specific to their hosts and cross-species reactivity is observed (1),(2). Communication using non-endogenous molecules is less sensitive than the original, and requires a higher signal concentration to take effect. This reduced sensitivity results in the slower activation of receivers, thus creating a system in which different receivers are activated after different amounts of time following signaling molecule release.

Introduction

Fig. 1　Burnt popcorn. He could have prevent this if he properly preset the timer...

Many electronic devices we use in our daily lives have the ability to keep track of time. For example, a VCR is able to record a TV program at a pre-set time, and a microwave automatically stops heating after a set amount of time. automatically stop heating when the right time comes. Using these temporal pre-programming functions, we have been liberated from either staying up late to watch a European soccer game or from worrying about our popcorn being burned black while yelling and shouting to the match we have videotaped. In this way, the timer function has revolutionized our lifestyle.

We thought the same applies to the biotechnology; we would like to freely implement the 'timer switches” to various biological functions, preferably both independently and in parallel format. These “functions” include sensors, synthesizers, or degraders of bioactive compounds/ materials, transportation and secretion machineries, communications, getting/ sticking together, proliferation and cell death. If successful, we will be able to program exceedingly more complex complex behaviors in cellular systems.

Fig. 2　Temporal imaging system. You can display secret message only for a short period of time. (reload to replay)
As one of the thousands of possible applications, we are trying to construct a temporal imaging system using E. coli 'ink' that differ not in color but the 'timing' at which they are a certain color (fig). Over time, parts of images (or characters) are getting visible one by one, making animated message/ picture. If the coloration process proceeds to completion, the message is obscured. Only when the message is observed at the correct timing during the coloration process is any useful information obtained. Such a system should be useful for communication security: we can convey our message to only those that know the exact moment they should take a look. After a while, the message is gone and cannot be retrieved.

Project Design

Fig. 3　System design

We designed a switching consortium that works like a water clock ([http://en.wikipedia.org/wiki/Water_clock Water clock-wikipedia.en]). Here is how it works (Fig 3).

1. Sender cells slowly generate signal molecules at a constant rate. The signal molecules are non-degradable (or virtually so in a reasonable time scale) so they get accumulated (linearly) over time.

2. Receivers detect the signal molecules and then activate the genetic switch to the on state, but only when the signal concentration reaches the switching threshold of a receiver. Receivers are activated by different signaling molecules at different rates. In this way, the entire system behaves like a delay switch sequence.

3. Either by changing the receiver sensitivity or rate of signal accumulation, one can freely control the delay length of the individual switches. Using switches with various times-of-delay, one can sequentially activate many different cellular functions.


Signaling System

In this project, we use acylated homoserine lactones (AHLs), signaling molecules used for [http://en.wikipedia.org/wiki/Quorum_sensing quorum sensing] in gram negative bacteria. Senders express LuxI or similar enzymes, which catalyze the production of AHLs, under the control of a constitutive (Tet) promoter. Each cell thus generates AHL more or less at a constant rate. AHL can freely permeate cell membranes and are detected by neighboring cells. Receivers constitutively express LuxR proteins (or a similar ortholog), the protein that detects AHL concentrations. When AHLs bind LuxR proteins, the AHL-LuxR complex activates the Lux promoter. The threshold [AHL] at which switching occurs is determined by the affinity of AHL for the particulr LuxR ortholog.(3),(4). (more about quorum sensing)

Constructing A Delay Switch, three ways:

  1. Speaker whispering
  2. Desensitize Receiver
  3. jamming by AiiA (decomposer)

List of Experiments

Delay Switching by Tuning Components

Fig.4 Chiba project design.jpg

Fig.5

Fig.6 LuxR mutant


Exp #1 Partial quenching of signals (jamming) Exp #2 Balancing Player Exp #3 Lux Mutants

Delay Switching by CrossTalk(7)

For detail, click each of the index titles

Fig.7

Fig.8

Exp #4 Spoken to by Foreign Senders Exp #5 Spoken to by Foreigners

Miscs


Temporal imaging system?



Conclusion

In conclusion, we tried (and are trying) to device a series of delay-switches by designing the "switching consortia". We got limited, by certain success in generating delay switches.

  1. We confirmed that various "foreign" AHL sender can activate the LuxR/ LuxP switch.
  2. Using the 3OC12HSL (Las-type) instead of 3OC6HSL (Lux-type) as signaling input, we could delay the activation of the LuxR/ LuxP switch for 2 hours. As of today, Oct 29th), this is the slowest delay switch in our hand.
  3. Interestingly, we kept failing to observe the crosstalk between Lux-sender and receivers from other organisms. Interestingly, we never seen the function of cinI/ cinR from Rhizobium leguminosarum. We have no idea why we could not reconstruct the communication (by this natural pairs).
  4. Several other strategies have been tested, too. We have positive expectation especially on the engineering of LuxR protein.
  5. Fiinally, we have provided 13 biobricks that will be useful in various future projects using cell-cell communications.

One of the technical challenge of our project was that the reporter genes are quite slow by itself to develop readable signal. There are significant time-lag between transcription initiation and the time the reporter start emitting the signal. We have screened many different reporters including lucifeases, lacZ, and other fluorescent proteins. With our experimental setup, they all looked more or less the same level (some were in the range of 30-60 mins in microscope, but all needed 90-120 mins to get visible by eye). For more precise PoPS analysis, we should have conduct blotting analysis, instead of fluorescent analysis.

References

  1. [http://www3.interscience.wiley.com/journal/119124142/abstract M.K Winson et al.:Construction and analysis of luxCDABE-based plasmid sensors　for investigating N-acyl homoserine lactone-mediated quorum sensing.FEMS Microbiology Letters 163 (1998) 185-192]
  2. [http://partsregistry.org/Part:BBa_F2620:Specificity BBa_F2620:Specificity]
  3. [http://www.pnas.org/content/100/suppl.2/14549.full Michiko E. Taga. Bonnie　L.Bassler.:Chemical communication among bacteria.PNAS.November 25, 2003,100.suppl.2]
  4. [http://arjournals.annualreviews.org/doi/abs/10.1146/annurev.micro.55.1.165?url_ver=Z39.88-2003&rfr_id=ori:rid:crossref.org&rfr_dat=cr_pub%3dncbi.nlm.nih.gov Melissa B. Miller and Bonnie L. Bassler.:QUORUM SENSING IN BACTERIA.annurev.micro.55.1.165.2001]
  5. [http://authors.library.caltech.edu/5553/ C. H. Collins.et al.:Directed evolution of Vibrio fischeri LuxR for increased sensitivity to a broad spectrum of acyl-homoserine lactones.Mol.Microbiol.2005.55(3).712–723]
  6. [http://mic.sgmjournals.org/cgi/content/abstract/151/11/3589 B. Koch. et al.:The LuxR receptor: the sites of interaction with quorum-sensing signals and inhibitors.Microbiology 151 (2005),3589-3602]
  7. [http://mic.sgmjournals.org/cgi/content/full/153/12/3923 Paul Williams :Quorum sensing, communication and cross-kingdom signalling in the bacterial world.Microbiology 153 (2007), 3923-3938]
  8. [http://pubs.acs.org/cgi-bin/abstract.cgi/acbcct/2006/1/i11/abs/cb6004245.html D. J. Sayut et al.:Construction and Engineering of Positive Feedback Loops.ACS Chemical Biology.1.No.11.(2006)]
  9. [http://www.sciencedirect.com/science?_ob=ArticleURL&_udi=B6WBK-4PRHJ6K-2&_user=136872&_rdoc=1&_fmt=&_orig=search&_sort=d&view=c&_version=1&_urlVersion=0&_userid=136872&md5=3ed7ffab9f831d102f5e99353843c080 D. J. Sayut et al.:Noise and kinetics of LuxR positive feedback loops.Biochem. Biophys. Res. Commun.363(3),2007,667-673.]
Home The Team The Project Parts Submitted to the Registry Reference Notebook Acknowledgements
Retrieved from "http://2008.igem.org/Team:Chiba/Project"