"
Isolated plasmid
From 2008.igem.org
(Difference between revisions)
Riachalder (Talk | contribs) (New page: * Pellet overnight culture by centrifuging 13,000g for 10 minutes. * Pipette out supernatent and discard. * Add 250μl resuspension buffer R3 and mix by pipetting up and down. * Transfe...) |
Riachalder (Talk | contribs) |
||
| Line 16: | Line 16: | ||
* Incubate for 1 minute at room temperature. | * Incubate for 1 minute at room temperature. | ||
* Centrifuge 13,000g for 2 minutes. The supernatent in the recovery tube should contain isolated plasmid. | * Centrifuge 13,000g for 2 minutes. The supernatent in the recovery tube should contain isolated plasmid. | ||
| - | * Discard spin column and store plasmid at -20°C. | + | * Discard spin column and store plasmid at -20°C. |
| - | + | ||
Revision as of 15:49, 16 September 2008
- Pellet overnight culture by centrifuging 13,000g for 10 minutes.
- Pipette out supernatent and discard.
- Add 250μl resuspension buffer R3 and mix by pipetting up and down.
- Transfer to capped tubes.
- Add 250μl lysis buffer L7 and mix by inverting tube 5 times.
- Incubate for 5 minutes at room temperature.
- Add 350μl precipitation buffer. Invert until mixture is homogenous.
- Centrifuge 13,000g for 10 minutes. Place spin column into recovery tube.
- Load supernatent into spin column and discard capped tube.
- Centrifuge 13,000g for 1 minute. Discard supernatent.
- Add 700μl wash buffer W9 (with ethanol).
- Centrifuge 13,000g for 1 minute. Discard supernatent.
- Centrifuge 13,000g for 1 minute to remove all liquid. Discard any remaining supernatent and recovery tube.
- Place spin column in new recovery tube.
- Add 100μl TE buffer or MilliQ H2O.
- Incubate for 1 minute at room temperature.
- Centrifuge 13,000g for 2 minutes. The supernatent in the recovery tube should contain isolated plasmid.
- Discard spin column and store plasmid at -20°C.
