(Difference between revisions)

NTU@iGEM Project Introduction Methodology Team Introduction Team background Notebook Dry Lab Introduction ODEs used Modeling Constructs Parameters used Deterministic Modeling Sensitivity Analysis Stochastic Modeling Wetlab Introduction Materials and Equipment Protocols Verification of Detection & Lysis System Our New Parts Characterization Introduction Standard Promoters Characterization of pLacI-GFP pLacI-GFP images and clips Characterization of pLsrA-YFP New characterization Proposal Parameter Estimation & Correlations Acknowledgements

Contents 1 Results 1.1 OD600 measurement of pLsrA-Lysis-containing LuxS mutant upon addition of AI-2 1.1.1 Initial Phase 1.1.2 After 1 hr

Results

OD600 measurement of pLsrA-Lysis-containing LuxS mutant upon addition of AI-2

Initial Phase

The following picture shows when AI-2 solution is added at initial time

Note that, cell only means there is only 200 µL cell in the well, AI-2, 2 means the AI-2 solution is collected at 2hrs. The results shows that with LB or water the cell culture reach higher steady state comparing to that with AI-2 solution as we can see the divergence at around 4hrs. all AI-2 solution (AI-2 3, 4, 5, 6, 8) except AI-2, 2 shows depressed steady state, indicating that, AI-2 is actually working

After 1 hr

The following picture shows when AI-2 solution is added at 1hr later

This also shows the expected result, with AI-2 present, the cell culture shows a lower steady state.

This error bar graph shows OD600 of each sample at different time intervals together with the standard deviation. It is clear from the graph that the variance of data is much smaller than the absolute value. Hence, the data obtained from the absorbance-meter is highly reliable.