Introduction

The use of models to describe synthetic biology has its merits. Synthetic biology investigates the use of different biological parts to put together and assemble devices that carry out specific functions. Good mathematical models to describe each part would greatly help not only in the characterization of a part but also facilitate the use of the part by other people when they choose to use the part within their devices or systems.

Simulations based on modeling can give a first insight on how the system would turn out and provide a rough guide of the system’s behaviour.

System

The system can be viewed as two parts. The first part comprises of lactose induced production of colicin E7 and the immunity protein. The second part comprises of a detection mechanism that produces the lysis protein upon the detection of both Iron ions and Ai-2 ( Autoinducer 2).

ODEs used in modeling

The following equations shows the break down of the different equations that will be used in this modeling exercise. By understanding this section, it would make the understanding of the system of ODEs used

Constant synthesis & Linear Synthesis

• Simple ode to describe constant synthesis
• Gives an explicit analytical solution
• Unique solution once a IC is posed

Linear Degradation

• Rate of degradation is proportional to how much of the molecule is present
• Gives an explicit analytical solution
• Constant half life

Simple Forward Reaction

This equation ignores the fact that dissociation of the complex occurs. We can do so if the dissociation is much slower than the formation.

• Single solvable equation for the unknown C
• Simple, unique solution available with I.C

Phosphorylation and Dephosphorylation

Assumptions:

• Linear kintic rate laws apply only if XT is much less than the Michaelis constants of both kinase and phosphotase

• Modeled after simple linear kinetics
• Gives a hyperbolic signal response curve when X plotted vs S

Regulated Transcription

Results of Modeling

E7 prodcution system

Modeling of the System shows that Lactose induction is essential to produce E7 and a variation of Lactose input can result in different yeilds of E7

Lysis Production system

Here we define 1 as a certain threshold e.g. (<250 µM) that when the lysis protein reaches it, lysis in the cell definitely occurs. Although we wish for an absolute AND gate, where 0 will have no lysis production at all, simulation on biological systems shows that such results are impossible. Both addition Fe ions and Ai-2 alone would induce a certain level of lysis production. However when both are available, the lysis protein production would be higher.

In the presence of Ai-2 alone, Lysis will most likely still occur albeit at a slower rate compared to situation when both Fe and Ai-2 are present.

With the addition of iron and Ai-2 together the rate of lysis production is still significantly much higher compared to Ai-2 alone.

Therefore, by giving the logical output ‘1’ as a suitable threshold value of Lysis protein production higher than that of Ai-2 induction alone, we would still be able to obtain an AND gate based on our definition.