Team:ETH Zurich/Wetlab/Chemostat Selection

Chemostat selection

Goal

The goal of our project is to find the minimal genome that is able to sustain a living E. coli in a specific environmental condition. In the previous section, we have introduced the method we want to apply for reducing the genome. However, manually selecting for those bacteria that have successfully reduced their genomes is obviously impossible. Therefore, we have to find a mechanism that automatically selects cells possessing a reduced genome.

Idea

Our idea is to set up a continuous bacterial culture in which cells with a reduced genome overgrow those maintaining more chromosomal DNA.

However, bacteria with a smaller genome do not automatically grow faster than those containing more DNA. This is due to the fact that the rate of proliferation is influenced not only by the replication velocity, but also by other factors such as protein synthesis, etc. Therefore, we have to introduce a constraint that renders DNA synthesis the limiting factor of the growth rate. In this scenario, reducing chromosomal DNA would speed up replication leading to fastest growth of those cells with the smallest genome. This way, we would not have to look for bacteria with reduced genomes, but we could let them do it for us!

Method

Chemostat

A chemostat is the instrument of choice for setting up a continuous culture. It is characterized by a continuous influx of medium, and an efflux of bacterial culture of the same volume. Since the volume of the continuous culture is kept constant, the growth rate of the population can be set by the dilution rate. Under these conditions, slowly growing (growth rate < dilution rate) cells will be washed out of the culture, while the fastest growing clone will take the lead and finally dominate the entire culture.

A model of the selection mechanism can be found in Chemostat Selection, where we estimate the initial parameters for optimal selection.

Figure 1: A chemostat

Growth constraint

As mentioned above, we want to introduce a constraint that renders DNA synthesis the limiting factor of the growth rate. DNA synthesis in bacterial cells is accomplished using the following biosynthetic pathway:

Figure 2: DNA biosynthetic pathway

The thymidylate synthase catalyzes the methylation of dUMP to yield dTMP. Phosphorylation then converts dTMP into dTTP, one of the four building blocks of DNA. In contrast to the other three nucleotides DNA is made of, dTTP is exclusively used for DNA, but not for RNA synthesis. Therefore, impairing the activity of the thymidylate synthase should interfere quite specifically with DNA synthesis.

Our idea is to knockout the thymidylate synthase of the E. coli strain we use for genome reduction and then add thymidine to the continuous culture in a concentration that renders DNA synthesis the limiting factor for the growth rate.

The underlying assumption is that a thymidylate synthase knockout can no longer synthesize DNA from glucose and thus depends entirely on the availability of thymidine in the medium. Therefore, if the thymidine concentration is kept low, DNA replication should be slowed down. A decreased replication rate then results in a slower growth rate. This way, by fixing the thymidine supply rate, we can influence the growth rate of the knockout mutant.

Supporting our assumptions, Escartin et al. showed that an E. coli strain expressing an enzymatically less active thymidylate synthase shows a significantly lower incorporation rate of radioactively labeled thymidine into DNA indicating a reduced replication velocity (1). The same strain grows poorly in thymidine-deprived growth media. Other reports support that a decreased replication rate results in a slower growth rate and decreased replicative fitness (2).

Lab results

Growth experiments with E. coli thymidine auxotrophic strain from [http://ecoli.naist.jp/gb6/Resources/deletion/deletion.html Keio library]

Before we were able to perform the knockout of the thyA gene in our working strains (see section below), we decided to test the effect of external thymidine supply on growth rates by using an available thymidine auxotrophic strain. Our goal was to understand if growth rates could be controlled using different thymidine concentrations in the medium. We used the thyA knockout strain from the Keio library (5) and performed the experiment in a BioLector machinery. The Biolector instrument takes lightscattering online measuraments from a 96 wells titer plate every 5 minutes. The plate is continuously rotated while oxygen supply and humidity are kept constant. We devised an experiment in which different Keio strain populations were made to grow in different wells under different concentrations of thymidine. The series consisted of 8 different dilutions, with concentrations varying from 0.001, 0.050, 0.01, 0.5, 10, 50, 100 to 500 ug/ml. Our goal was to asses the strengths of the effects. We also included controls: the wild type strain was subjected to the very same concentrations as the auxotrophic strains without adding thymidine. The results are summarized in the growth profiles shown below.

Figure 3: Growth profiles of thymidine auxotrophic strain subjected to different thymidine concentrations.

The growth rates were minimal in all wells with 0.5 ug/ml or less thymidine. For the wells with 0.50 ug/ml or more thymidine concentration we found a pattern of full growth (partly due to errors of measurement caused by evaporation, and probably due to thymidine which was potentially left from the overnight colture). For the wells with a concentration of 0.10 ug/ml, we noticed a clear limitation in growth rate resulting in a growth profile in between the other two conditions. This effect was confirmed by two technical replicates. The controls showed the expected behavior: the thymidine deprived auxotrophic strain did not show any growth response and wild type strains showed a regular growing profile for all thymidine concentrations. This was an unexpected result that led to two important conclusions: thymidine concentration could be used effectively to control growth rate to a certain extent (extent yet to be fully characterized) and permitted us to identify the range of concentrations in which thymidine is supposed to be effective in controlling growth rates.

Growth experiments with E. coli strains of different genomic sizes

To test our hypothesis of selecting for strains with smaller genome size in a chemostat setup, we have chosen to compare growth behaviour (growth rate and thymidine yield) of strains with different genome size. For this purpose we used MG1655 and MDS42, two strains with the same background, with different genome size. MDS2 has a 14.3% smaller genome size than MG1655. We ordered both at [http://www.scarabgenomics.com/ ScarabGenomics ].

For a first characterization of the growth behavior of these two strains, we performed growth experiments in LB medium.

Figure 4: MG1655 and MDS42 were cultivated in 500ml baffled flasks with 100ml LB medium at 37°C and 220 rpm. Cell growth was assessed by measuring the optical density at 600 nm.

We observed a higher growth rate for MG1655 than for MDS42 in LB medium, while growing to the same cell density.

Labeling of E. coli strains of different genomic sizes

Since growth of two strains in the same environment is not observable by measurement of the optical density, we decided to label them by expression of two different fluorescent proteins. Our initial idea was to integrate these fluorescent proteins into the chromosomes of MG1655 and MDS42 using the lambda red recombination system established by Wanner and Datsenko (6). However, after successfully generating the GFP- and RFP-encoding PCR products needed for recombination, we repeatedly failed to integrate the PCR products into the chromosomes. Therefore, we opted for labeling via plasmids.

To this end we have constructed a RFP generator and a GFP generator on low-copy plasmids (pCK01) and transformed them into MG1655 and MDS42. An important issue, when labeling strains with different genome size in order to compare their genome size specific behavior, is to use plasmids with the same copy-number to keep the relative difference of needed amount of nucleotides the same. We have chosen to use a low-copy plasmid to keep the added protein burden low. To ensure that the fluorescence signal is proportional to cell concentration, we compared measurements of the optical density with the fluorescence signal. We therefore measured the fluorescence signal of a dilution series of MG1655 and MDS42 labeled with RFP and GFP respectively with a [http://las.perkinelmer.com/Catalog/ProductInfoPage.htm?ProductID=1420-050 fluorescence reader].

Figure 5: We optimized the fluorescence reader to measure the amount of our fluorescence proteins by using amongst others specific emission and excitation filters. A dilution series of different amounts of cells show the linear correlation to the optical density of cells.

The fluorescence signal for both fluorescent proteins, RFP and GFP, showed a linear response between OD600 0.5 and 6, which is the range of optical density important to follow growth of E. coli.

In order to assure a correlating signal also during growth of E. coli we followed MG1655 labeled with GFP by measuring the optical density and at the same time the fluorescence signal.

Figure 6: MG1655 labeled with GFP were grown in 500ml shake flasks with 100ml LB medium at 37°C and 220rpm. Growth has been followed by measurement of optical density at 600nm and fluorescence intensity.

The expression of GFP in MG1655 correlates also to the measured optical density.

Thymidylate synthase knockout using phage transduction

The knockout of thyA in MG1655 and MDS42 were performed by P1 vir transduction (3). For this we used a thyA mutant from the [http://ecoli.naist.jp/gb6/Resources/deletion/deletion.html keio collection] as the donor cells to transfer its kanamicin-resistence gene into MG1655 and MDS42. The mutants from the keio collection are single knockouts which have each one single gene replaced by a kanamicin-resistence gene. Different verification methods were performed to verify successful knockout of thyA in MG1655 and MDS42. First we selected the transduced strains on kanamicin-plates, second we performed an XGal-test to distinguish colonies of the donor cells (keio thyA mutant) from the colonies of the receptor cells (MG1655 and MDS42) and third by growth on minimal glucose medium with and without supplemented thymidine (40ug/ml). Since BW25113, the strain of the keio collection, is lac- (∆lacZ4787(::rrnB-3)) and MG1655 and MDS42 lac+, XGal-screen is a fast method to distinguish residual donor cells in the phage lysate from the receptor cells. For further verification we will perform a colony PCR of the mutants.

Growth experiments with thymidylate synthase knockout strains

We performed growth experiments with the knockout mutants in minimal glucose medium with different supplemented thymidine concentrations.

At a thymidine concentration of 80 ug/ml MG1655 thyA- and MDS42 thyA- show a similar growth behavior.

Figure 7: MG1655 thyA- and MDS42 thyA- were grown in 500ml baffled shake flasks with 100ml minimal glucose medium with 80 ug/ml supplemented thymidine at 37°C and 220rpm. Growth has been followed by measuring the optical density.

Whereas on 10 ug/ml thymidine concentration MDS42 thyA- grows to a much higher cell concentration.

Figure 8: MG1655 thyA- and MDS42 thyA- were grown in 500ml baffled shake flasks with 100ml minimal glucose medium with 10 ug/ml supplemented thymidine at 37°C and 220rpm. Growth has been followed by measuring the optical density.

This shows that at limiting thymidine concentrations MDS42 thyA-, which has a reduced genome size, has a growth advantage in comparion to MG1655 thyA-. This effect might select for cells with smaller genome size in a chemostat setup.

In future work MG1655 thyA- and MDS42 thyA- will be labeled with RFP and GFP respectively to follow outgrow of one strain by the other when cultivated together in a chemostat and to continue examining our hypothesis.

Strains used in the experiments of this section

Keio thymidylate synthase knockout strains

• BW25113: ∆(araD-araB)567, ∆lacZ4787(::rrnB-3), lambda-, rph-1, ∆(rhaD-rhaB)568, hsdR514

Phage transduction knockout strains

• MG16555 thyA: F-, lambda-, rph-1, thyA-
• MDS42 thyA: F-, lambda-, rph-1, thyA-

References

(1) [http://www.pnas.org/content/105/29/9948 Escartin F., Skouloubris S., Liebl U., Myllykallio H. (2008): Flavin-dependent thymidylate synthase X limits chromosomal DNA replication. Proc Natl Acad Sci 22 105(29):9948-52.]

(2) Helmstetter C. (1996): Timing of synthetic activities in the cell cycle. Escherichia coli and Salmonella: Cellular and Molecular Biology. eds Neidhardt FC et al. (Am Soc Microbiol, Washington D. C.): 1627–1639.

(3) [http://mrw.interscience.wiley.com/emrw/9780471142720/cp/cpmb/article/mb0117/current/html Lynn C. et al. (2007): E. coli Genome Manipulation by P1 Transduction. Current protocols in molecular biology]

(4) [http://www.sciencemag.org/cgi/content/full/312/5776/1044 Pósfai G, Plunkett G 3rd, Fehér T, Frisch D, Keil GM, Umenhoffer K, Kolisnychenko V, Stahl B, Sharma SS, de Arruda M, Burland V, Harcum SW, Blattner FR. Emergent Properties of Reduced-Genome Escherichia coli. Science. 2006 May 19;312(5776):1044-6. Epub 2006 Apr 27.]

(5) Baba et al, Construction of Escherichia coli K-12 in-frame, single-gene knockout mutants: the Keio collection, Mol Syst Biol. 2006; 2: 2006.0008.

(6) [http://www.pubmedcentral.nih.gov/articlerender.fcgi?tool=pubmed&pubmedid=10829079 Datsenko K. A., Wanner B. L. (2000): One-step inactivation of chromosomal genes in Escherichia coli K-12 using PCR products. Proc Natl Acad Sci 97 (12):6640-5.]