Team:University of Ottawa/10 July 2008

From 2008.igem.org

Revision as of 18:50, 16 July 2008 by Morto077 (Talk | contribs)

Contents

Today in the lab

Dan

Gel of S&D&T PCR products
  • The bands I needed were on the gel, they were somewhat close to non specific binding bands, so I took extra caution when cutting them out.
  • After using the gel extraction kit the obtained concentrations were decent.
  • PCR amplification of S&D&T
  • Performed PCR on the S&D&T obtained products, if it works, It would be easy to obtain more DNA and would save the hassle of going back to step 1.
  • Atcre and construct 1 concentrations
  • Both these DNA fragments resulted in very low concentrations following gel extraction. Chris went ahead and used Atcre anyways. The concentration of construct 1 was too low to use.
  • Talked to Cory and realized that AgeI could be used instead of ClaI. That would solve our problem of performing ligation on a 2bp overhang.
  • We ordered new primers today for this.
  • Looking back

  • After Matt encountered problems with reduced enzymatic activity of restriction enzymes, I decided to redigest and reconfirm
  • Matt

    PCR confirmation
  • Tested absorbance and Ran a PCR confirmation of IP producing cells (97 plasmid int. in BY4742 yeast strain) using both wild type BY4742 and H20 as control's.
  • Digestion of PTP2 Ligation Product
  • Another digestion of PTP2 was attempted using EcoRI - sadly I did not get the bands I needed, it seems the PTP2 was not correctly integrated into the Vector.