Team:ETH Zurich/Wetlab/Chemostat Selection
From 2008.igem.org
Chemostat selectionGoalThe goal of our project is to find the minimal genome that is able to sustain a living E. coli in a specific environmental condition. In the previous section, we have introduced the method we want to apply for reducing the genome. However, manually selecting for those bacteria that have successfully reduced their genomes is obviously impossible. Therefore, we have to find a mechanism that automatically selects cells possessing a reduced genome. IdeaOur idea is to set up a continuous bacterial culture in which cells with a reduced genome overgrow those maintaining more chromosomal DNA. However, bacteria with a smaller genome do not automatically grow faster than those containing more DNA. This is due to the fact that the rate of proliferation is influenced not only by the replication velocity, but also by other factors such as protein synthesis, etc. Therefore, we have to introduce a constraint that renders DNA synthesis the limiting factor of the growth rate. In this scenario, reducing chromosomal DNA would speed up replication leading to fastest growth of those cells with the smallest genome. This way, we would not have to look for bacteria with reduced genomes, but we could let them do it for us! MethodChemostatA chemostat is the instrument of choice for setting up a continuous culture. It is characterized by a continuous influx of medium, and an efflux of bacterial culture of the same volume. Since the volume of the continuous culture is kept constant, the growth rate of the population can be set by the dilution rate. Under these conditions, slowly growing (growth rate < dilution rate) cells will be washed out of the culture, while the fastest growing clone will take the lead and finally dominate the entire culture. A model of the selection mechanism can be found in Chemostat Selection, where we estimate the initial parameters for optimal selection.
Growth constraintAs mentioned above, we want to introduce a constraint that renders DNA synthesis the limiting factor of the growth rate. DNA synthesis in bacterial cells is accomplished using the following biosynthetic pathway:
Our idea is to knockout the thymidylate synthase of the E. coli strain we use for genome reduction and then add thymidine to the continuous culture in a concentration that renders DNA synthesis the limiting factor for the growth rate. The underlying assumption is that a thymidylate synthase knockout can no longer synthesize DNA from glucose and thus depends entirely on the availability of thymidine in the medium. Therefore, if the thymidine concentration is kept low, DNA replication should be slowed down. A decreased replication rate then results in a slower growth rate. This way, by fixing the thymidine supply rate, we can influence the growth rate of the knockout mutant. Supporting our assumptions, Escartin et al. showed that an E. coli strain expressing an enzymatically less active thymidylate synthase shows a significantly lower incorporation rate of radioactively labeled thymidine into DNA indicating a reduced replication velocity (1). The same strain grows poorly in thymidine-deprived growth media. Other reports support that a decreased replication rate results in a slower growth rate and decreased replicative fitness (2). Lab resultsGrowth experiments with E. coli thymidine auxotrophic strain from [http://ecoli.naist.jp/gb6/Resources/deletion/deletion.html Keio library]Before we were able to perform the knockout of the thyA gene in our working strains (see section below), we decided to test the effect of external thymidine supply on growth rates by using an available thymidine auxotrophic strain. Our goal was to understand if growth rates could be controlled using different thymidine concentrations in the medium. We used the thyA knockout strain from the Keio library (5) and performed the experiment in a BioLector machinery. The Biolector instrument takes lightscattering online measuraments from a 96 wells titer plate every 5 minutes. The plate is continuously rotated while oxygen supply and humidity are kept constant. We devised an experiment in which different Keio strain populations were made to grow in different wells under different concentrations of thymidine. The series consisted of 8 different dilutions, with concentrations varying from 0.001, 0.050, 0.01, 0.5, 10, 50, 100 to 500 ug/ml. Our goal was to assess the strengths of the effects. We also included controls: the wild type strain was subjected to the very same concentrations as the auxotrophic strains without adding thymidine. The results are summarized in the growth profiles shown below. The growth rates were minimal in all wells with 0.5 ug/ml thymidine or less. For the wells with 0.50 ug/ml thymidine or more, we found a regular growth pattern (partly due to errors of measurement caused by evaporation, and probably also due to thymidine which could have been left from the overnight colture). For the wells with a concentration of 0.10 ug/ml, we noticed a clear limitation in the growth rate resulting in a growth profile in between the other two conditions. This effect was confirmed by two technical replicates. The controls showed the expected behavior: the thymidine deprived auxotrophic strain did not show any growth response and wild type strains showed a regular growing profile for all thymidine concentrations. This was an unexpected result that led to two important conclusions: thymidine concentration could be used effectively to control growth rate to a certain extent (extent yet to be fully characterized) and the experiment permitted us to identify the range of concentrations in which thymidine is supposed to be effective in controlling growth rates. Growth experiments with E. coli strains of different genomic sizesTo test if we can select for strains with smaller genome sizes in a chemostat setup, we have chosen to compare growth behaviors (growth rate and thymidine yield) of strains with different genome sizes. For this purpose we used MG1655 and MDS42, two strains with the same genetic background, but with different genome sizes. MDS2 has a 14.3% smaller genome size than MG1655. Both strains were ordered at [http://www.scarabgenomics.com/ ScarabGenomics ].
For a first characterization of the growth behaviors of these two strains, we performed growth experiments in LB medium.
We observed a higher growth rate for MG1655 than for MDS42 in LB medium, while both grew to the same cell density. Labeling of E. coli strains of different genomic sizesSince individual growth rates of two strains in the same environment cannot be assessed by measuring the optical density, we decided to label them with two different fluorescent proteins. Our initial idea was to integrate these fluorescent proteins into the chromosomes of MG1655 and MDS42 using the lambda red recombination system established by Wanner and Datsenko (6). However, after successfully generating the GFP- and RFP-encoding PCR products needed for recombination, we repeatedly failed to integrate the PCR products into the chromosomes. Therefore, we opted for labeling via plasmids. To this end we have constructed a RFP generator and a GFP generator on low-copy plasmids (pCK01) and transformed them into MG1655 and MDS42. When labeling strains with different genome sizes to compare genome size specific behavior, it is important to use plasmids with the same copy-number. This is to keep the relative differences in nucleotide usage the same. We have chosen to use a low-copy plasmid to keep the added protein burden low. To ensure that the fluorescence signal is proportional to the cell concentration, we compared measurements of the optical density with the fluorescence signals. To this end, we measured the fluorescent signals of a dilution series of RFP-labeled MG1655 and GFP-labeled MDS42 with a [http://las.perkinelmer.com/Catalog/ProductInfoPage.htm?ProductID=1420-050 fluorescence reader].
The fluorescent signal for both fluorescent proteins, RFP and GFP, showed a linear response between OD600 0.5 and 6, which is the range of optical density important to follow the growth of E. coli. In order to assure a correlating signal also during growth of E. coli, we followed the growth of MG1655 labeled with GFP by measuring the optical density and, at the same time, the fluorescence signal.
The expression of GFP in MG1655 correlates well with the measured optical density. Thymidylate synthase knockout using phage transductionThe knockouts of thyA in MG1655 and MDS42 were performed by P1 vir transduction (3). For this purpose, we used a thyA mutant strain from the [http://ecoli.naist.jp/gb6/Resources/deletion/deletion.html keio collection] as donor cells and transfered its kanamycin-resistence gene into MG1655 and MDS42. The mutants from the keio collection are single knockouts which each have one single gene replaced by a kanamycin-resistence gene. Different verification methods were performed to verify successful knockout of thyA in MG1655 and MDS42. First we selected the transduced strains on kanamycin-plates, second we performed an XGal-test to distinguish colonies of the donor cells (keio thyA mutant) from the colonies of the receptor cells (MG1655 and MDS42), and third by growth on minimal glucose medium with and without supplemented thymidine (40ug/ml). Since BW25113, the strain of the keio collection, is lac- (∆lacZ4787(::rrnB-3)) and MG1655 and MDS42 are lac+, XGal-screen is a fast method to distinguish residual donor cells in the phage lysate from the receptor cells. For further verification we will perform colony PCR of the mutants. Growth experiments with thymidylate synthase knockout strainsWe performed growth experiments with the knockout mutants in minimal glucose medium with different concentrations of supplemented thymidine. At a thymidine concentration of 80 ug/ml, MG1655 thyA- and MDS42 thyA- show similar growth behaviors.
On the other hand, at a thymidine concentration of 10 ug/ml, MDS42 thyA- grows to a much higher cell concentration.
This shows that at limiting thymidine concentrations MDS42 thyA-, which has a reduced genome size, has a growth advantage in comparion to MG1655 thyA-. This effect might select for cells with smaller genome sizes in a chemostat setup. In future work, MG1655 thyA- and MDS42 thyA- will be labeled with RFP and GFP, respectively, to follow outgrow of one strain by the other when cultivated together in a chemostat. Strains used in the experiments of this sectionKeio thymidylate synthase knockout strains
Phage transduction knockout strains
References(1) [http://www.pnas.org/content/105/29/9948 Escartin F., Skouloubris S., Liebl U., Myllykallio H. (2008): Flavin-dependent thymidylate synthase X limits chromosomal DNA replication. Proc Natl Acad Sci 22 105(29):9948-52.] (2) Helmstetter C. (1996): Timing of synthetic activities in the cell cycle. Escherichia coli and Salmonella: Cellular and Molecular Biology. eds Neidhardt FC et al. (Am Soc Microbiol, Washington D. C.): 1627–1639. (3) [http://mrw.interscience.wiley.com/emrw/9780471142720/cp/cpmb/article/mb0117/current/html Lynn C. et al. (2007): E. coli Genome Manipulation by P1 Transduction. Current protocols in molecular biology] (4) [http://www.sciencemag.org/cgi/content/full/312/5776/1044 Pósfai G, Plunkett G 3rd, Fehér T, Frisch D, Keil GM, Umenhoffer K, Kolisnychenko V, Stahl B, Sharma SS, de Arruda M, Burland V, Harcum SW, Blattner FR. Emergent Properties of Reduced-Genome Escherichia coli. Science. 2006 May 19;312(5776):1044-6. Epub 2006 Apr 27.] (5) Baba et al, Construction of Escherichia coli K-12 in-frame, single-gene knockout mutants: the Keio collection, Mol Syst Biol. 2006; 2: 2006.0008. (6) [http://www.pubmedcentral.nih.gov/articlerender.fcgi?tool=pubmed&pubmedid=10829079 Datsenko K. A., Wanner B. L. (2000): One-step inactivation of chromosomal genes in Escherichia coli K-12 using PCR products. Proc Natl Acad Sci 97 (12):6640-5.] |