Materials and Methods

From 2008.igem.org

(Difference between revisions)
Line 31: Line 31:
4. pRS305, Ga11P/Adh1t
4. pRS305, Ga11P/Adh1t
-
In some cases, finished constructs were subcloned as cassettes (using Kpn1 or PspOMI and SacI sites) into various pRS3__ series vectors to swap the marker.
+
In some cases, finished constructs were subcloned as cassettes (using Kpn1 or PspOMI and SacI sites) into various pRS3__ series vectors to swap the markers.
 +
 
 +
The regional silencing construct was constructed by PCR amplification of a Cyc1P-mCherry-Adh1t cassette with Kpn1 ends, which was cloned into the Kpn1 site upstream of the 5' LexA operators in the GFP reporter plasmid.  

Revision as of 06:49, 28 October 2008

Materials and Methods

1. General Cloning/Molecular biology

Constructs were cloned using the AarI method, developed by Sergio Pesajovich the 2007 UCSF iGEM team. To learn more about AarI cloning:

Everything you ever wanted to know about AarI

In brief: yeast genomic DNA was used as a template to PCR amplify "parts". Parts were TOPO cloned, validated by sequencing, and then combinatorially cloned into the following AarI adapted acceptor vectors:


To make the silencers:

1. pRS315, Adh1P/Adh1t

2. pRS315, Cyc1P/Adh1t

3. pRS315, Fig1P/Adh1t

4. pRS305, Ga11P/Adh1t


To make the reporters: (same plasmids as above, with a 5' or 3' 8X LexA operator array)

1. pRS315, Adh1P/Adh1t

2. pRS315, Cyc1P/Adh1t

3. pRS315, Fig1P/Adh1t

4. pRS305, Ga11P/Adh1t

In some cases, finished constructs were subcloned as cassettes (using Kpn1 or PspOMI and SacI sites) into various pRS3__ series vectors to swap the markers.

The regional silencing construct was constructed by PCR amplification of a Cyc1P-mCherry-Adh1t cassette with Kpn1 ends, which was cloned into the Kpn1 site upstream of the 5' LexA operators in the GFP reporter plasmid.


Yeast Strains

SF992/W303 or CB008: W303 MATa, Ste5::KanR, bar1::NatR, far1D, his 3, trp1, leu2, ura3 (for pheromone experiments) were transformed with finished plasmids using standard protocols. The dual-tagged strain used for the cooperativity experiment was built in SF992, and was gal2::NatR, allowing graded activation of galactose inducible promoters (Media:Hawkins and Smolke.pdf).


2. Silencing Assay In cases where galactose induction was required, yeast were re-streaked on complete or dropout synthetic Raffinose plates, plus or minus 2% galactose. Overnight cultures in the same media were diluted in the morning (typically 1:50 or 1:100), and 3 hours later, at OD600 0.05-0.1 range, flow cytometry measurements were taken using a BD LSR-II flow cytometer (BD Biosciences). For each sample, 10,000 cells were counted, and GFP fluorescence was measured by exciting at 488 nm with a 100 mW Coherent Sapphire laser. For experiments with pheromone-inducible promoters, cultures were grown to early log phase (OD600=0.1-0.3) in complete synthetic dropout media and then treated with 1 μM α-factor (Zymo Research) to activate the pathway. Cultures were analyzed after 3 hours of growth.


Representative flow cytometery plots are shown for all experiments, but each experiment was conducted in triplicate (using different clones) with consistent results.


Home The Team The Project Parts Submitted to the Registry Modeling Human Practices Notebooks