Team:BCCS-Bristol/Calendar-Notebook/9 July 2008

From 2008.igem.org

(Difference between revisions)
m
Line 15: Line 15:
</div>
</div>
-
Made some aspartate solution 0.1% and put on disc on plates with equidistant points. innoculated with MG1655 on .15, .3 and .5% agar then incbated overnight at 25, 30 and 37<sup>o</sup>C all with 3 replicates
+
==Swimming agar assay with aspartic acid==
 +
We conducted a second swimming agar assay with ''E. coli'' MG1655. This time, we added paper discs that were soaked with a L-aspartic acid solution. We wanted to observe whether the bacteria are attracted by the amino acid. We tested again different parameters:
-
Took photos of swiiming agar and measure distance travelled, found 0.3% to be the best for an overnight culture. all plates showed swarm spread at diff levels giving outer rings.
+
- agar concentrations of 0.15 %, 0.3 % and 0.5 %
 +
 
 +
- incubation temperatures of 25 <sup>o</sup>C, 30 <sup>o</sup>C and 37 <sup>o</sup>C
 +
 
 +
- inoculations depths of "on the surface", "under the surface" and "deep in the medium"
 +
 
 +
- aspartic acid concentrations of 0.2 %, 0.1 % and 0.01 %
 +
 
 +
 
 +
 
 +
Photos of swiming agar were taken and travelled distances measured. 0.3% agar was found to be the best for an overnight culture and a temperature of 37<sup>o</sup>C was too high, since the swarms spread over the whole plate. All plates showed swarm spread at different levels giving inner and outer rings. Unfortunately, we observed no different movement/growth towards the L-aspartic acid compared with the control (water). It was assumed that this is due to the low concentration, but it wasn't possible to made a 0.4 % solution.

Revision as of 17:36, 5 August 2008

Swimming agar assay with aspartic acid

We conducted a second swimming agar assay with E. coli MG1655. This time, we added paper discs that were soaked with a L-aspartic acid solution. We wanted to observe whether the bacteria are attracted by the amino acid. We tested again different parameters:

- agar concentrations of 0.15 %, 0.3 % and 0.5 %

- incubation temperatures of 25 oC, 30 oC and 37 oC

- inoculations depths of "on the surface", "under the surface" and "deep in the medium"

- aspartic acid concentrations of 0.2 %, 0.1 % and 0.01 %


Photos of swiming agar were taken and travelled distances measured. 0.3% agar was found to be the best for an overnight culture and a temperature of 37oC was too high, since the swarms spread over the whole plate. All plates showed swarm spread at different levels giving inner and outer rings. Unfortunately, we observed no different movement/growth towards the L-aspartic acid compared with the control (water). It was assumed that this is due to the low concentration, but it wasn't possible to made a 0.4 % solution.