Team:Heidelberg/Notebook/Visualization/Notebook/SwarmAssays

From 2008.igem.org

(Difference between revisions)
(Swarm Assays)
(Second Experiment (01.10.2008)=)
Line 505: Line 505:
-
===Second Experiment (01.10.2008)====
+
===Second Experiment (01.10.2008)===
-
 
+
-
 
+
-
 
+
===Third Experiment===
===Third Experiment===

Revision as of 16:37, 29 October 2008


Contents

Swarm Assays

STARTED 2008-09-27


PURPOSE:
Test of the abbility of strains expressing the fusion receptor, to move against an attractant gradient.


STRAIN:
As autoinducer 2 producing attactant strain DH5α was used.
The fusion receptor plasmid was further cloned into HCB33 and UU1250 strains.


METHOD:
Petri-dishes were used es running chambers.
A petri-dish was filled with a media containig agar. Then the attractant was spotted on premarked positions or spotted as a line through the center of the petri-dish. After the gradient of the attractant has etablished the strains whioch should be attracted by the attractant where also set on premarked positions. The whole petri-dish was incubated at 37 °C and pictures were taken after 24, 48 and 72 hours.
For a more detailed protocol visit the Methods page.


A few pictures which have been taken during these experiments can be viewed under Projects.



First swarm plates

A swarm assay test in 4 swarm plates was prepared.
2 different fusion constructs were used. Each in HCB33 and in UU1250.
Every petri-dish was filled with 20 ml of media. Two with minimal media containing about 0.3 % agar and the other two with TB media containing 0.2 % agar.

On a center line of both minimal plates and on one of the TB plates two spots of DH5α were created.
Afterwards fusion contruct 1 containing bacteria HCB33 and UU1250 were each spotted on the right half with an equal distance to the attractant spots. The same was done with the fusion construct 2 containing bacteria strains, but on the other half of the plate.



Second Experiment (01.10.2008)

Third Experiment

Fourth Experiment

back to the visualization notebook