USTC/Notebook/PCR&Colony PCR

From 2008.igem.org

Revision as of 13:43, 27 October 2008 by Jones (Talk | contribs)

< Back to Notebook

PCR

Briefly, a typical reaction is set up as follows:


1. set up pre-labeled reaction tubes on ice

2. add the following components: - 2µL PCR buffer (rock gently after thawing, quick spin before use) - 1.2uL Mgcl2 - 0.4uL dNTPs - 200nM final concentration of each primer - 0.2uL Taq enzyme - template DNA (note: the total volume of PCR is 20µL)


3. make sure reaction tubes are properly capped before placing in thermocycler


4. perform PCR with an initial heating step at 94C for 5 minutes followed by 25-35 cycles of 30sec at 94C, 30sec at 55C and 1Kb/min at 72C


colony PCR

0.2 uL primer #1 (to 25uM) 0.2 uL primer #2

0.4 uL dNTPs 

2 uL Buffer 5 uL colony culture 0.2 uL Taq 10.4 uL H20

perform PCR with an initial heating step at 94C for 5 minutes followed by 25-35 cycles of 30sec at 94C, 30sec at 55C and 1Kb/min at 72C,and 72C for 10min